Cervis TM70 Manuel d'installation télécharger pdf (Page 22)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

6.3 Transmitter Power Monitoring

The transmitter is equipped with a battery level monitor. When the

transmitter voltage level drops below a pre-established limit, the

transmitter LED flashes RED for a five minute grace period to allow the

operator time to move the load to a safe position. Do not use the stop

button during this time until the load is in a safe position! If the

STOP button is used within the 5-minute grace period, the transmitter

will not start again until a fresh battery is installed.

Battery power level is indicated on the screen of transmitters with an LCD. Power level is

indicated by the number of segments displayed on screen. Values are:

3 segments

2 segments

1 segment

0 segments

— Charge greater than 50%

— Charge between 10 and 50%

— Charge between 5 and 10%

— Charge below 5%

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 102 103

Pas de commentaire

Cervis TM70 Manuel d'installation Page 22